Ian Piper

Ian
Piper
Articles
Design An E-pHEMT 4.9-to-6.0-GHz LNA
This two-stage design makes use of enhancement-mode pHEMT device technology to serve IEEE 802.11a, HiperLAN2, and HiSWANa local-area-network receivers.
Build An E-pHEMT Low-Noise Amplifier 3
Although often associated with power amplifiers, E-pHEMT devices are also quite capable of supporting the design of efficient low-noise amplifiers.
Whitepapers

How to Do Fixture De-Embedding to Match Signal Integrity Simulations to Measurements​
Sponsored by Keysight Technologies
Download this white paper


Testing S-Parameters on Pulsed Radar Power Amplifier Modules​
Sponsored by Rohde & Schwarz
Download this white paper

 

 

 

Webcasts

Perform Power Supply Frequency Response Analysis using an Oscilloscope
May 19, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


PAM-4 Transmitter and Receiver Design Characterization Solutions
May 21, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


DisplayPort 1.3 – PHY Layer Test Requirements
May 27, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


Extraction, Verification, and Usage of a Short Haul Opto VCSEL Model
May 28, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×