Joseph F. White

Joseph F.
White
Articles
Cascading Amp Stages For Higher Gain
One goal of cascading amplifier stages is to achieve higher levels of gain without sacrificing gain flatness across the design bandwidth of interest.
Achieving High Gain Over Broad Bandwidths
By computer optimizing key circuit elements and applying negative feedback, level transistor gain can be achieved over very broad bandwidths.
Approach Yields Low-Noise Amplifiers
The available gain method permits amplifier designers to achieve moderate gain while minimizing noise figure at a given target frequency.
Applying The Operating Gain Design Approach
The operating-gain design method gain provides higher levels of gain than earlier design approaches, although it may not guarantee unconditional stability.
Method Simultaneously Matches Inputs and Outputs
For the case of an unconditionally stable transistor, it is possible to simultaneously match the devices input and output ports to the load and source.
Approach Increases Amplifier Gain
The unilateral gain design technique can be applied to tune a transistors input and output circuitry for more gain.
Ensure Stability In Amplifier Designs
Knowledge of stability circles and S-parameters can help to develop input and output matching circuits that deliver stable amplifier performance at a desired frequency.
Applying S-Parameters To Amplifier Design
This opening installment of an eight-part design series explains the concept of S-parameters and how they can be used to create basic transistor bias circuitry.
Whitepapers

How to Do Fixture De-Embedding to Match Signal Integrity Simulations to Measurements​
Sponsored by Keysight Technologies
Download this white paper


Testing S-Parameters on Pulsed Radar Power Amplifier Modules​
Sponsored by Rohde & Schwarz
Download this white paper

 

 

 

Webcasts

Perform Power Supply Frequency Response Analysis using an Oscilloscope
May 19, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


PAM-4 Transmitter and Receiver Design Characterization Solutions
May 21, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


DisplayPort 1.3 – PHY Layer Test Requirements
May 27, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


Extraction, Verification, and Usage of a Short Haul Opto VCSEL Model
May 28, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×