Wei Hong

Wei
Hong
Articles
Transmitter/Receiver Manages MIMO

Fast data transfers usually require large bandwidths. But the use of multiple-input, multiple-output (MIMO) antenna techniques can also boost data rates for available bandwidths, as shown with this high-performance two-way transmitter and receiver design operating with a 100-MHz bandwidth at 8.05 GHz. It boasts excellent performance, with a receiver noise figure of 2.7 dB and transmitter output power of +17 dBm at 8.05 GHz and associated third-order intermodulation (IM3) level of −41.4 dBc.

Front End Fits SDR Picocells
This compact RF front end meets the needs of multi-band, multimode transmit and receive requirements in software-defined-radio (SDR) picocell stations.
Tune Out Spurious In Dual-Mode BPFs
By optimizing a microstrip filters coupling structure, it is possible to achieve small size and wide rejection bandwidth while accounting for fabrication tolerances.
TD-SCDMA Receiver Captures Multiple Channels
This high-performance receiver works with multiple active antenna modules and a digital intermediate-frequency (IF) stage to support wireless multicarrier and diversity receiving systems.
Equalize RF Amplifiers With Bandpass Filters
The amplitude response of a broadband RF transmit amplifier can be dramatically flattened by using the complementary characteristic of a bandpass filter.
Optimized Transceiver Aids Broadband Wireless Access
This compact module is based on commercial ICs and standard PCB substrate, with the clever placement of filters to suppress unwanted transmitter spurious products.
Whitepapers

How to Do Fixture De-Embedding to Match Signal Integrity Simulations to Measurements​
Sponsored by Keysight Technologies
Download this white paper


Testing S-Parameters on Pulsed Radar Power Amplifier Modules​
Sponsored by Rohde & Schwarz
Download this white paper

 

 

 

Webcasts

Perform Power Supply Frequency Response Analysis using an Oscilloscope
May 19, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


PAM-4 Transmitter and Receiver Design Characterization Solutions
May 21, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


DisplayPort 1.3 – PHY Layer Test Requirements
May 27, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!


Extraction, Verification, and Usage of a Short Haul Opto VCSEL Model
May 28, 2015 @ 1pm EST
Sponsored by Keysight Technologies
Register Now!

Connect With Us

Sponsored Introduction Continue on to (or wait seconds) ×