Mwrf 1247 Meca P 0
Mwrf 1247 Meca P 0
Mwrf 1247 Meca P 0
Mwrf 1247 Meca P 0
Mwrf 1247 Meca P 0

Power Splitters Minimize PIM

April 4, 2014
Power Splitters Minimize PIM
A series of reactive power splitters includes Model LPR3D-1.950WWP for low-passive-intermodulation (PIM) applications from 1,700 to 2,200 MHz. Available in two and three-way versions with 7/16 DIN or Type-N connectors at all ports, the splitters cut PIM levels to at least −153 dBc and typically –160 dBc. They are rated for 120-W power with maximum insertion loss of 0.6 dB and typical insertion loss of 0.5 dB. The worst-case VSWR for these 50-Ω splitters is 1.35:1, with typical VSWR of 1.25:1. Typical amplitude balance is ±0.35 dB while typical phase balance is ±4° from port to port. The splitters are designed for operating temperatures from –55 to 85°C.

MECA Electronics Inc., 459 East Main St., Denville, NJ 07834, (866) 444-6322, (973) 625-0661, FAX: (973) 625-9277, www.e-MECA.com

Sponsored Recommendations

Frequency Modulation Fundamentals

March 14, 2024
The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

March 14, 2024
The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Feb. 19, 2024
Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...

Using a CMT VNA with Socket Server

Feb. 19, 2024
This application note describes use of a software application CMT Socket Server which is distributed and supported by Aphena Ltd. Please email [email protected] regarding purchase...