Optimize Testing Of Multi-Standard-Radio Devices

Nov. 5, 2012
With a single multi standard radio (MSR) base station unit now able to transmit GSM, WCDMA, and LTE multiple carriers simultaneously, the accurate and efficient testing of those MSR base station transmitter devices has become critical to their success.

Base stations have faithfully evolved as cellular telecommunications networks migrated from second- to third-generation (2G to 3G) technologies. As cellular networks migrate to 3.9G or even fourth-generation (4G) technologies, however, base-transceiver-station (BTS) transmitters must be reinvented. From what was originally a single-carrier, narrowband design for 2G GSM/TDMA networks, they evolved into  multi-carrier wideband designs (3/3.5G) and now will have to transition to a software-defined-radio (SDR) architecture. In a five-page application note, Agilent Technologies provides guidance on how multi-standard-radio (MSR) base-station transmitter devices can be tested quickly, accurately, and efficiently.

Titled “Solutions for Testing Multi-Standard Radio Base Stations,” the note explains that next-generation base-station transmitters and receivers will support wider bandwidths. In addition, they will include multiple carriers (MCs) of a single radio format as well as multiple formats in one transmitter path. For example, the MSR base station can simultaneously transmit different radio-access technologies (RATs) from a single unit. While such capabilities will drive down base-station cost and size, they also invite a challenge: the conformance testing of MSR base stations in accordance with the 3GPP Release 9 (TS37 series) standard.

The TS37 document covers the MSR MC combinations of 3GPP frequency-division-duplexing (FDD) and time-division-duplexing (TDD) formats. Transmitter conformance tests have to be performed under MSR MC allocating scenarios. The document defines MSR RF test requirements by specifying measurement of the following when testing MSR MC-active configurations: channel power, error vector magnitude (EVM), frequency error, spurious emissions, and spectrum emission mask (SEM).

To provide a realistic use scenario, base-station manufacturers may also want to test each single-format single carrier. Such testing calls for measurement of the adjacent-channel leakage ratio (ACLR), occupied bandwidth, and time alignment between transmitter branches. The note provides details of how all of this testing can be done in an optimized manner using signal analyzers and vector-signal-analyzer (VSA) software. With the accurate and efficient testing of MSR base-station transmitter devices, the note emphasizes that it is possible to ensure their successful deployment. 

Agilent Technologies, Inc., 5301 Stevens Creek Blvd., Santa Clara, CA 95051; (877) 424-4536, www.agilent.com.

Sponsored Recommendations

Frequency Modulation Fundamentals

March 14, 2024
The development of crystal-clear FM communications was an innovation of genius and toil. Utilized today in applications such as radar, seismology, telemetry and two-way radios...

44 GHz Programmable Signal Generator

March 14, 2024
The Mini-Circuits SSG-44G-RC is a 0.1 to 44 GHz signal source with an RF output range of -40 to +17 dBm with fine resolution. This model supports CW and pulsed (? 0.5 ?s) outputs...

Webinar: Introduction to OTA Measurement for mmWave and Sub-THz

Feb. 19, 2024
Join Jeanmarc Laurent, a leading expert from MilliBox, for an exclusive live webinar showcasing a complete Over-the-Air (OTA) testing system setup. In this immersive session, ...

Using a CMT VNA with Socket Server

Feb. 19, 2024
This application note describes use of a software application CMT Socket Server which is distributed and supported by Aphena Ltd. Please email [email protected] regarding purchase...