What is in this article?:
While IEEE 802.11ac is an extension of the existing 802.11n specification, IEEE 802.11ad represents a completely new paradigm. Today, the 2.4- and 5-GHz wireless bands for the earlier 802.11 standards are heavily congested. They also lack the capacity to deliver the extreme data rates required for emerging business and consumer applications. The multi-gigabit data rates required for uncompressed high-definition multimedia transmissions—including known futures like 4k and 8k digital cinema (3840 x 2160 and 7680 x 4320 pixels respectively) and three-dimensional (3D) video streaming—must be accommodated in a different way.
Ultimately, data capacity is tied to modulation bandwidth. And extreme data capacity calls for a large spectrum allocation. The simplicity of high-volume manufacturing demands that this modulation bandwidth should be a small percentage of the transmission frequency. The global unlicensed band that already exists at around 60 GHz (where multi-gigahertz modulation bandwidths are practical) meets that requirement.
Because 60-GHz transmission suffers from large attenuation when propagating through physical barriers, this usage model is different from the other IEEE 802.11 standards. Low-power transmissions will not propagate very far. This is considered an advantage, as it reduces the likelihood of co-channel interference and increases the potential density for frequency re-use. Another perceived advantage of limited range is the reduced opportunity for "theft" of protected content by eavesdropping on nearby transmissions.
The unlicensed frequency allocations at around 60 GHz in each region do not match exactly. But there is substantial overlap. At least 3.5 GHz of contiguous spectrum is available in all regions that have allocated spectrum.
The ITU-R-recommended channelization comprises four channels that are each 2.16-GHz wide. They are centered on 58.32, 60.48, 62.64, and 64.80 GHz. As Figure 3 illustrates, not all channels are available in all countries. Channel 2, which is globally available, is therefore the default channel for equipment operating in this frequency band. In November 2011, this channelization and the corresponding spectrum mask for the occupying signal were approved by ITU-R WP 5A for global standardization.
3. The 60-GHz-band channel plan and frequency allocations are shown by region.
Today, devices and subsystems in the 60-GHz band for consumer technology are a commercial reality, thanks to high-yield, low-cost, micron-geometry components. Multiple-antenna configurations using beam-steering are an optional feature of the specifications. They can be employed to circumnavigate minor obstacles, such as people moving around a room or a piece of furniture blocking line-of-sight transmission. Longer free-space distances (e.g., beyond 10 m) and more substantial obstructions (e.g., walls, doors, etc.) will prevent transmission.
There is, however, a major challenge when it comes to system testing. Component and system design and test at 60 GHz is a well-understood and established science, but its application to high-volume, low-cost devices for the consumer market is new. Tools for millimeter-wave circuit design and simulation, network analysis, signal analysis, and power measurements have been available for years in applications like short-range radar and military communications. IEEE 802.11ad boasts much wider modulation bandwidth than other wireless communications systems. In addition, the physical construction of the devices is unique. The system shown in Figure 4 offers an example of the equipment needed for transmitter and receiver testing.
4. Among the test-equipment solutions targeting these specifications is the IEEE 802.11ad Physical Layer Signal Generation and Analysis System.
In summary, IEEE 802.11ac and 802.11ad both provide much higher data throughputs than their predecessors. Yet they have much different potential uses. IEEE 802.11ac is an evolution of previous WLAN capability. It gives the “unwired office” the ability to compete directly with gigabit wired systems while offering much better layout and connection flexibility. In contrast, IEEE 802.11ad is a new solution that provides ad-hoc short-range connectivity in support of extremely high data rates.